Using CCSv12.6.0 + C2000Ware 5.01 to setup a working Target config for LAUNCHXL_F28P65x: Is there a known issue? Can you please help with the below error message? I ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

The I2C operation mode is I2C_OPER_MODE_POLLING, and SENSOR_I2C_TIMEOUT is 5000. When the camera's I2C communication is abnormal, it can sometimes cause the MCU2_0 OS to block for about 18 seconds.

Referring to the list of clock identifiers in the link and also refer the clock summary taken from /sys/kernel/debug/clk ...

Hi, I'm looking to order samples of TPS653860-Q1 shortly but can only find documentation on default OTP configurations/order codes for O386001QDCARQ1 & O386301QDCARQ1 in the secure resources folder.

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

I would like to know on the use of TPS6594-Q1 with AM5716AABCXEA. Currently we are using TPS659162RGZR. Is TPS659162RGZR being discontinued? Are there any issues with using the AM5716AABCXEA?

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

Now I'm trying to enable the voice-activity-detection function(VAD) on TLV320ADC5120 EVK board, but failed: no interrupt occurs when the signal gets into EVK.

I am making Phase shift full bridge converter by using TMS320F280039C. I am running the voltage controller in CLA as below. Voltage controller execution time is 3us. So running CLA at 300kHz. I want ...